MTU C23R Instructions d'exploitation télécharger pdf (Page 9)

2. Screw locknut (2) onto screw (1) up to the end of the thread.

3. The long end of holder (3) must face downwards. Push holder (3) through the plate openings (6).

Note: The holders (3) must lock the flywheel only, not the ring gear.

4. Install screw (1) into the bore of holder (1) until the holder (1) is locked in position.

Note: Tighten screw (1) alternately on both sides of the flywheel housing.

5. Tighten screw (1) alternately to specified tightening torque.

Name Size Type Lubricant Value/Standard

Screw M10 Tightening torque (Engine oil) 30 Nm +3 Nm

6. Fit locknut (2) of screw (1) on plate (6) and secure.

Removing the transport locking

device from driving end (KS)

1. Release the locknut (2) on both sides of

the flywheel housing, remove screw (1) and

take off the two holders (3).

2. Unscrew screws (4) and remove together

with washers (5) and plate (6).

3. Store the removed parts of the transport

locking device together with this documen-

tation carefully for possible reuse.

M015695/03E 2013-03 | Safety | 9

TIM-ID: 0000035999 - 002

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 162 163

Pas de commentaire

MTU C23R Instructions d'exploitation Page 9